ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
308 Manual Transmission-Transaxle, Clutch and Transfer Case > < Intake Air Temperature (IAT) Sensor

Puma 1998 (06.1997-12.2001)

Electronic Engine Controls - Heated Oxygen Sensor (HO2S) Puma 1998 (06/1997-12/2001)
Removal and Installation

Removal

WARNING:
WARNING:The exhaust system may be hot, which may result in personal injury if touched.
  1. Remove the right-hand exhaust manifold heat shield.

  1. Remove the left-hand exhaust manifold heat shield.

  1. Disconnect the heated oxygen sensor electrical connector.

  1. Remove the sensor.

Installation

WARNING:
WARNING:The exhaust system may be hot, which may result in personal injury if touched.
CAUTION:
CAUTION:When installing a new HO2S, it is possible that the new component will be supplied with a longer cable than the one removed. It is important that the cable is routed and secured in such a way that it cannot be damaged by heat or moving components and will not cause a noise, vibration or harshness (NVH) issue.
  1. To install, reverse the removal procedure.

308 Manual Transmission-Transaxle, Clutch and Transfer Case > < Intake Air Temperature (IAT) Sensor