| Removal and Installation | | -
Disconnect the negative battery cable and wait for 1 min or more.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
Remove the driver-side air bag module.
For additional information, refer to: Driver Air Bag Module (501-20B Supplemental Restraint System, Removal and Installation).
| | | -
Remove the steering wheel. For additional information, refer to: Steering Wheel (211-04 Steering Column, Removal and Installation). | | | -
Remove the column cover.
For additional information, refer to: Steering Column Shrouds (501-05 Interior Trim and Ornamentation, Removal and Installation).
| 5. Remove the components in the order indicated in the following illustration(s) and table(s). 6. To install, reverse the removal procedure. | | -
Turn the ignition switch to the ON position. | | | -
Verify that the air bag system warning light illuminates for approx. 6 s and goes out. - If the air bag system warning light does not operate, refer to the on-board diagnostic system (air bag system) and perform inspection of the system.
| Installation Details Item 3 : Clockspring | | -
CAUTION:If the clockspring is not adjusted, the spring wire in the clockspring could over-wind and break when the steering wheel is turned. Always adjust the clockspring after installing it. Adjust the clockspring after installing it.
For additional information, refer to: Clockspring Adjustment (501-20B Supplemental Restraint System, General Procedures).
| |
