Ranger 2WD V6-3.0L VIN U (1998)
-
If HEAVY contamination is present or fluid is burnt, replace the Transmission (F87Z-7000-JARM for 1998 models or XL5Z-7000-AARM for
1999-2000 models). Flush the transmission cooler line system forward and backward (lines only). Replace Radiator (XL2Z-8005-LA).
-
If MINIMAL contamination is present, replace the Extension Housing (F77Z-7A039-CA) and Gasket (D4ZZ-7086-B). Clean the transmission oil
pan and install a new transmission fluid pan gasket. Reinstall transmission oil pan and flush transmission cooling system forward and backward (lines
and cooler).
SCENARIO # 2:
-
If extension housing bushing IS NOT in the proper location within the bore, replace the Transmission (F87Z-7000-JARM for 1998 models or
XL5Z-7000-AARM for 1999-2000 models).
-
If HEAVY contamination is present, flush the transmission cooler line system forward and backward ('lines only) and replace Radiator
(XL2Z-8005-LA).
-
If MINIMAL contamination is present, flush transmission cooling system forward and backward (lines and cooler).
c.
MANUAL TRANSMISSION ONLY: Inspect extension housing bushing for damage or out-of-location within the bore for the following
two scenarios:
SCENARIO # 1 :
-
If extension housing bushing IS in the proper location, drain the transmission oil, inspect fluid for contamination, and determine if fluid is burnt.
-
If HEAVY contamination is present or fluid is burnt, replace the Transmission with (MF87A-7003-CA).
-
If MINIMAL contamination is present, drain the transmission fluid, replace the Extension Housing (F2TZ-7A039-A), use Ford-approved RTV
sealant: F7TZ-19554-AA (or equivalent meeting Ford specification ESB-M4G92-A) and refill with MERCON(R)V Automatic Transmission Fluid
(XT-5-QM).
SCENARIO # 2:
If extension housing bushing IS NOT in the proper location within the bore., replace the Transmission (MF87A-7003-CA).
d.
AUTOMATIC AND MANUAL TRANSMISSIONS CONTINUED:
-
Install a new driveshaft and make sure that the driveshaft and axle alignment marks are aligned. Refer to Parts Block for proper driveshaft usage.
-
Fill transmission fluid to the proper level using MERCON(R)V Automatic Transmission Fluid (XT-5-QM).
