Ranger 2WD V6-4.0L (2010)
Rear Bumper Bracket: Service and Repair
Bumper Bracket - Rear
Removal and Installation
1. Remove the rear bumper beam. For additional information, refer to Bumper - Rear, Beam See: Service and Repair/Bumper - Rear, Beam.
2. Remove the bolt and nut from the outer bumper bracket-to-inner bumper bracket.
-
To install, tighten to 115 Nm (85 lb-ft).
3. Remove the 2 bolts from the inner bumper bracket-to-frame and remove the inner bumper bracket.
-
To install, tighten to 115 Nm (85 lb-ft).
4. To install, reverse the removal procedure.
