Ranger 2WD V6-4.0L (2010)
Installation
1. NOTE: Make sure the tab is in the lock position.
NOTE: Install 2 new O-rings on the transmission case (16-pin) electrical connector.
Install the transmission case (16-pin) electrical connector.
-
Lubricate the transmission case (16-pin) electrical connector O-rings with petroleum jelly.
2. Press the transmission case (16-pin) electrical connector through the case until a click is heard.
3. NOTE: Align the slot on the TSS sensor electrical connector with the slot in the (16-pin) case connector.
Install the TSS sensor wire.
1. Install the TSS sensor wire into (16-pin) case connector.
2. Install the TSS sensor wire into the locator.
4. NOTICE: Do not overstretch the retaining spring. Overstretching can damage the spring.
Install the transmission case (16-pin) electrical connector retaining spring.