Ranger 4WD L4-140 2.3L VIN A EFI (1997)
Oil Pick Up/Strainer: Service and Repair
Oil Strainer, Engine
REMOVAL
1. Remove engine.
2. Remove oil pan.
3. Remove nut, two screws, oil pump screen cover and tube and oil pump inlet tube gasket.
INSTALLATION
1. Thoroughly clean oil pump screen cover and tube.
2. Clean all mounting surfaces.
(Part 1 Of 2)
(Part 2 Of 2)
3. Install oil pump screen cover and tube and oil pump inlet tube gasket.
4. Install two screws, and nut.
5. Tighten screws to 20-30 Nm (14-22 ft. lbs.).