Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
3. Remove the slip-yoke boot from the driveshaft.
^
Inspect the boot for damage. Discard the boot as necessary.
4. Inspect the lubricant on the driveshaft splines and in the driveshaft slip-yoke for contamination. If contaminated, inspect the driveshaft splines and
the driveshaft slip-yoke for wear. Install new components as necessary.
Assembly
1. Position the new small driveshaft slip-yoke boot clamp on the driveshaft stub shaft.
2. Slide the small opening end of the slip-yoke boot on the driveshaft stub shaft, as far as it will travel.
3. Using the special tool, crimp the driveshaft slip-yoke boot clamp.
