Ranger 4WD L4-153 2.5L SOHC VIN C SFI (2001)
4. Install the driveshaft slip-yoke on the driveshaft.
1. Pull the slip-yoke boot toward the driveshaft. Lubricate the driveshaft splines with approximately 10 grams (0.24 oz.) of lubricant.
^
Use Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-M1C75-B.
2. Position the new large slip-yoke boot clamp.
3. Align the index-marks, and install the driveshaft slip-yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.
1. Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2. Position the slip-yoke boot in the slip-yoke boot groove.
3. Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the end of the driveshaft slip-yoke.
4. Bleed the air from the slip-yoke boot.
6. Using the special tool, crimp the large driveshaft slip-yoke boot clamp.