Ranger 4WD L4-2.3L VIN D (2002)
Evaporator Case: Service and Repair
REMOVAL
NOTE:
-
The evaporator core is not separately serviceable, it is serviced only with the evaporator core housing assembly.
-
If an evaporator core leak is suspected, the evaporator core must be leak tested before it is removed from the vehicle.
-
Replacement of the suction accumulator is not required when repairing the refrigerant system except when there is physical evidence of system
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Remove the suction accumulator.
3. Remove the A/C compressor.
4. Remove the engine oil indicator and tube.
5. Disconnect the blower motor and blower motor resistor electrical connectors.
6. Disconnect the heater hoses.
1
Using suitable tools, clamp-off the heater hoses.
2
Release the clamps and disconnect the heater hoses.
7. Detach the pin-type retainer and position aside the windshield washer hose.
8. Disconnect and detach the heater control valve vacuum hose.