Ranger 4WD L4-2.3L VIN D (2002)
9. Disconnect the vacuum supply hose near the evaporator core housing.
NOTE: 2.3L engine shown, others are similar.
10. Disconnect the condenser to evaporator line spring lock coupling from the evaporator core inlet.
-
Discard the O-ring seals.
11. Disconnect the vacuum hose connector and remove the nut.
NOTE: This step is performed at the lower passenger side dash panel, inside the passenger compartment.
12. Remove the nuts and the evaporator core housing.
INSTALLATION
1. To install, reverse the removal procedure.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil or equivalent.