Ranger 4WD L4-2.3L VIN D (2002)
2. Cut and strip the wires near the electrical connector.
3. Obtain two wires (20 gauge minimum) at least 6.1 meters (20 feet) long and attach one end of each wire to stripped ends of the pretensioner wires.
4. Place the pretensioner on a flat surface in an open outdoor area.
5. Remain at least 6.1 meters (20 feet) away from the safety belt pretensioner.
6. Deploy the safety belt pretensioner by touching the other ends of the two wires to the terminals of a 12-volt battery.
7. To allow for cooling, wait at least ten minutes before approaching the deployed safety belt pretensioner.
8. Dispose of the deployed safety belt pretensioner in the same manner as any other part to be scrapped.
