Ranger 4WD L4-2.3L VIN D (2002)
Drive/Propeller Shaft: Service and Repair
Rear
Driveshaft-Rear
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Index-mark the driveshaft flange to the rear axle pinion flange.
3. Remove the four rear axle flange bolts.
4. Index-mark the driveshaft and the extension housing.
5. CAUTION: The driveshaft flange fits tightly on the rear axle pinion flange pilot. Never hammer on the driveshaft or any of its components to
disconnect the driveshaft flange from the pinion flange. Pry only in the area shown, with a suitable tool, to disconnect the driveshaft Range from
the pinion flange.
Using a suitable tool as shown, disconnect the driveshaft flange from the rear axle pinion flange.