Ranger 4WD V6-177 2.9L (1988)
Steering Wheel: Service and Repair
REMOVAL
1.
Disconnect battery ground cable (two ground cables on diesel engines).
2.
From underside of steering wheel, remove screws attaching horn pad to steering wheel spokes.
3.
Lift up steering wheel pad, then disconnect horn wires and electrical connectors from pad.
4.
Remove steering wheel attaching bolt and damper, if equipped.
5.
Remove steering wheel using steering wheel remover T67L-3600-A or equivalent, Do not use a knock-off type wheel puller or strike end of
steering shaft, as damage will result.
INSTALLATION
1.
Position steering wheel on end of steering shaft, aligning mark and flats on steering wheel with mark and flats on steering shaft, and ensuring that
straight ahead steering wheel position corresponds with straight ahead position of front wheels.
2.
If equipped, install damper and align locators with hole in wheel hub.
3.
Install steering wheel attaching bolt and torque to 23-33 ft. lbs.
4.
Connect horn wires and electrical connectors, then install horn pad.
5.
Connect battery ground cable (two ground cables on diesel engines), then check steering column for proper operation.
