Ranger 4WD V6-182 3.0L (1994)
Anti-Lock Brake (RABS) Module: Service and Repair
REMOVAL
1. Disconnect the wiring harness from the anti-lock electronic control unit by depressing the plastic tab on the connector and pulling the connector
off.
2. Disconnect the wiring harness from the IWW module by depressing the plastic tab on the connector and pulling the connector off.
RABS Control Module
3. Remove the screw and nut that retain the anti-lock electronic control unit and bracket assembly to the instrument panel. Remove the anti-lock
electronic control unit and bracket assembly.
4. Remove the screws that retain the anti-lock electronic control unit to the instrument panel bracket. Remove the anti-lock electronic control unit.
INSTALLATION
1. Place the anti-lock electronic control unit in position on the instrument panel bracket. Install and tighten the RABS II module retaining screws.
2. Place the anti-lock electronic control unit and bracket assembly in position in the instrument panel. Install and tighten the retaining nut and screw.
3. Connect the wiring harness to the RABS II and IWW modules.
4. Check the system for proper operation.