Ranger 4WD V6-4.0L (2009)
-------------------------------------------------
C2 CHECK FOR CHARGING SYSTEM DTCs IN THE PCM
-
Enter the following diagnostic mode on the scan tool: PCM Self-Test.
-
Retrieve the continuous memory DTCs from the PCM.
-
Is DTC P0620, P0625, P0626 or P065B set in the PCM?
Yes
REFER to Charging System.
No
GO to C3.
-------------------------------------------------
C3 CHECK THE BATTERY CONDITION AND STATE OF CHARGE
-
Ignition OFF.
-
Check the battery condition and verify the battery is fully charged. Refer to Battery, Battery Condition Test.
-
Is the battery OK and fully charged?
Yes
GO to C4.
No
REFER to Charging System.
-------------------------------------------------
C4 CHECK THE SJB VOLTAGE SUPPLY
-
Measure and record the voltage at the battery.
-
Disconnect: SJB C2280A.
-
Ignition ON.
-
Measure the voltage between the SJB C2280A-1, circuit SBB01 (RD), harness side and ground.
-
Is the voltage within 0.2 volt of the recorded battery voltage?
Yes
GO to C5.
No
REPAIR the circuit for high resistance. CLEAR the DTC. REPEAT the self-test.
-------------------------------------------------
C5 CHECK THE SJB GROUND CIRCUIT
-
Ignition OFF.
-
Disconnect: Negative Battery Cable.
-
Disconnect: SJB C2280C.
-
Measure the resistance between the SJB C2280C-1, circuit GD174 (BK/WH), harness side and ground.