Ranger 4WD V6-40L (2009) Drive/Propeller Shaft Service and Repair
4. Remove the 4 front driveshaft bolts and the U-joint straps.
-
Discard the bolts.
-
Upon installation, install new bolts and tighten to 19 Nm (168 lb-in).
5. Remove the front driveshaft.
6. NOTICE: The can (domed constant velocity [CV] joint housing cover) is pressed into the CV joint housing at the factory. When housed
correctly, the can will appear as shown in the cut-away illustration (top box). Do not reseat the can in the CV joint housing if the can's
flange is above the CV joint housing as shown in the cut-away illustration (bottom box) or vehicle damage may occur. Install a new
driveshaft.
NOTICE: Tighten the constant velocity (CV) joint bolts evenly in a cross pattern or damage will occur to the CV joint.
NOTE: Verify that the U-joint bearing caps are seated in the pinion yoke flange before tightening the U-joint strap bolts.
To install, reverse the removal procedure.
Driveshaft - Four Wheel Drive (4WD)
Driveshaft - Four Wheel Drive (4WD)