Removal and Installation Special Tool(s) | 204-605 Separator, Lower arm-ball joint | | 204-607 Remover, Ball joint | | 204-609 Protection Cap, Ball Joint Gaiter | Removal NOTE:Removal steps in this procedure may contain installation details. | -
Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). | | -
CAUTION:Make sure that the ball joint ball does not rotate. Torque: 70 Nm | | -
-
WARNING:Make sure that no load is placed on the brake hose. Torque: 200 Nm | | -
-
CAUTION:Make sure that new bolts are installed. Torque: Stage 1: 140 Nm Stage 2: 45° | Installation | -
To install, reverse the removal procedure. | | -
Check the toe setting and adjust as necessary. Refer to: Front Toe Adjustment (204-00 Suspension System - General Information, General Procedures). | | |