Removal and Installation General Equipment Removal | -
Remove the spring. Refer to: Spring (204-02 Rear Suspension, Removal and Installation). | | -
Install the spacer. Make sure that the spacer is in a vertical plane and raise the suspension to the design height setting. | Installation | -
NOTE:Only tighten the nut and bolts finger tight at this stage. | | -
Install the spacer between the rear lower arm and the body side rail. Make sure that the spacer is in a vertical plane and raise the suspension to the design height setting. | | -
Install the spring. Refer to: Spring (204-02 Rear Suspension, Removal and Installation). | | -
Check the toe setting and adjust as necessary. Refer to: Rear Toe Adjustment (204-00 Suspension System - General Information, General Procedures). Refer to: Specifications (204-00 Suspension System - General Information, Specifications). | | |