ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
General Procedures|Removal and Installation|Removal > < Halfshaft Seal RH

S-MAX.Galaxy 2006.5 (03.2006-)

Manual Transmission/Transaxle - Vehicles With: 6-Speed Manual Transmission (M66) - Input Shaft Seal S-MAX/Galaxy 2006.5 (03/2006-)
Removal and Installation

Special Tool(s)
303-336
Remover, Crankshaft Rear Seal

308-643
Installer, Input Shaft Seal

Removal

  1. Remove the transmission.
    Refer to: Getriebe - 2.5L Duratec-ST (VI5) (308-03 Schaltgetriebe - Fahrzeuge ausgestattet mit 6-Gang Schaltgetriebe (M66), Removal).
  1. Remove the clutch slave cylinder.
    Refer to: Kupplungsnehmerzylinder (308-02 Kupplungsbetätigung - Fahrzeuge ausgestattet mit 6-Gang Schaltgetriebe (M66), Removal and Installation).

  1. CAUTION:
    CAUTION:Take special care to avoid damaging the bearing.
    Special Tool(s): 303-336

  1. Screw a 2.5 x 15 mm self-tapping screw a maximum of two turns into the input shaft seal and pull out the input shaft seal using a pair of pliers.

Installation
  1. CAUTION:
    CAUTION:Use adhesive tape to cover the input shaft splines to prevent damage to the input shaft seal.
    Special Tool(s): 308-643
  1. Remove the adhesive tape from the input shaft splines and install the clutch slave cylinder.
    Refer to: Kupplungsnehmerzylinder (308-02 Kupplungsbetätigung - Fahrzeuge ausgestattet mit 6-Gang Schaltgetriebe (M66), Removal and Installation).
  1. Install the transmission.
    Refer to: Getriebe - 2.5L Duratec-ST (VI5) (308-03 Schaltgetriebe - Fahrzeuge ausgestattet mit 6-Gang Schaltgetriebe (M66), Installation).
  1. Bleed the clutch system.
    Refer to: Kupplungssystem entlüften (308-00, General Procedures).

General Procedures|Removal and Installation|Removal > < Halfshaft Seal RH