Removal and Installation Special Tool(s) | 501-130 Punching Tool, Parking Aid Sensor | General Equipment 15 mm drill bit Flat file Hot glue gun Knife Round-ended steel rule Removal NOTE:Removal steps in this procedure may contain installation details. | -
Remove the rear wheels. Refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation). | | -
If equipped. Torque: 95 Nm | Vehicles with VIN plate body code: M Vehicles with VIN plate body code: S Installation Vehicles with VIN plate body code: M | -
NOTE:Cutlines may already exist on the inner surface of a new bumper cover. On both sides. | Vehicles with VIN plate body code: S | -
NOTE:Cutlines may already exist on the inner surface of a new bumper cover. NOTE:Make sure that the measuring tape has contact to the inner surface of the bumper cover while measuring. On both sides. | All vehicles | -
-
Align the flattened side horizontal upwards, before punching each hole. | | -
NOTE:Make sure that the correct parking aid sensor housing is used as a template to mark the position of the location grooves. | | -
NOTE:Make sure that the correct parking aid sensor housing is used as a template to mark the position of the location grooves. | | -
NOTE:Make sure that the correct parking aid sensor housing is used as a template to mark the position of the location grooves. | | -
NOTE:Make sure that the correct parking aid sensor housing is used as a template to mark the position of the location grooves. | Vehicles with VIN plate body code: M Vehicles with VIN plate body code: S All vehicles | -
To install, reverse the removal procedure. | |