Removal and Installation Removal | -
Drain the master cylinder reservoir. - Using a suitable container and tubes, release both the front brake bleed nipples. Pump the brake pedal until no resistance is felt.
| | -
Release three exhaust insulators. - Allow the exhaust to rest on the rear cross beam.
| | -
Remove the rear heat shield (seven fastenings). | | -
Disconnect the multiplug. | | -
Remove the cable support bracket (two screws). | | -
Release the brake pipes (four clips). | | -
Detach the hydraulic unit (three bolts). | | -
Disconnect the multiplug. | | -
Disconnect the six brake pipes. - Remove the unit and bracket.
| | -
Remove the bracket (three nuts). | | -
Detach the hydraulic unit from the rubber mountings. - Lift the unit off the bracket.
| Installation | -
Refit the components in reverse order. | | |