ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
412-02 Heating and Ventilation > < Vacuum Leak Detection

Streetka 2003.5 (01.2003-07.2005)

Climate Control System - General Information - Fluorescent Dye Leak Detection Streetka 2003.5 (01/2003-07/2005)
General Procedures

General Equipment
UV Spot Lamp
Manifold Gauge Set
Fluorescent Dye Injector
NOTE:
NOTE:Vehicles built 07/1999 onwards have a fluorescent tracer dye tablet inserted into the air conditioning (A/C) system. If tracer dye is present, there is a green cross on the suction accumulator.
NOTE:
NOTE:On vehicles built up to 07/1999 tracer dye must be added.
  1. Using the dye injector, add 7.4 ml of Fluorescent Tracer Dye.
NOTE:
NOTE:Some vehicles may have signs of refrigerant oil at the spring lock couplers. This may be caused from the assembly process which applies to the fittings before installation to aid in assembly. When a spring lock coupler is suspected of leaking, always wipe the fitting clean and verify the leak with R-134a Automatic Calibration Halogen Leak Detector.
NOTE:
NOTE:The exact location of leaks can be pinpointed by the bright yellow - green glow of the tracer dye. Since more than one leak may exist, always inspect each component.
  1. Check for leaks using a 120 Watt UV Spot Lamp. Always scan all components, fittings and lines of the A/C system.
  1. After the leak is found and repaired, remove any traces of dye with a general purpose oil solvent.
  1. Verify the repair by operating the system for some minutes and inspecting with the UV lamp again.

412-02 Heating and Ventilation > < Vacuum Leak Detection