Taurus V6-182 3.0L DOHC SHO (1992)
By-Pass Air (BPA) Valve: Service and Repair
REMOVAL
Throttle Body
1.
Disconnect air bypass valve assembly connector from the wiring harness.
2.
Remove top retaining screw and swing valve up to gain access to lower screw. Remove lower mounting screw.
3.
Remove air bypass valve and gasket.
INSTALLATION
1.
Ensure that both throttle body and air bypass valve gasket surfaces are clean.
NOTE: If scraping is necessary, be careful not to damage air bypass valve or throttle body gasket surfaces, or drop material into throttle body.
2.
Install gasket on throttle body surface and mount air bypass valve assembly, securing it with two retaining screws to 63-97 lb in (7.1-11 Nm).
3.
Connect electrical connector for air bypass valve.
