Taurus V6-182 3.0L VIN 1 FI Flex Fuel (1997)
7. If the runout is not within specification, remove the rotor and measure the hub flange mounting face outside of the stud circle for runout. Hub Face
Maximum Runout, 0.04mm (0.0016 inch)
8. If the runout of the hub flange exceeds specification, install a new hub assembly and repeat flange face runout measurement. Reinstall the rotor and
repeat the rotor runout measurement.
9. If the runout of the hub flange is within specification, reindex the rotor and repeat the measurement.
10. If the rotor still exceeds the specification, refinish or replace the rotor as required. Reindex the rotor and repeat the runout measurement.
11. Reinstall the caliper and caliper bracket.