Taurus AWD V6-3.5L (2009)
Seats with manual recline
4. Position the manual recliner and drive the 2 large roll pins into the cushion frame and through the front manual recliner eyelets.
Seats with power recline
5. Position the power recliner to the cushion frame and install the 3 bolts.
-
Tighten to 10 Nm (89 lb-in).
6. Drive the 2 large roll pins into the cushion frame and through the front power recliner eyelets.
7. Connect the power recliner electrical connector.
Heated seats
8. Slide the heated seat module onto the bracket, making sure it is locked in place and install the rivet. Connect the heated seat module electrical
connector.
Seats with an OCS system service kit
9. WARNING: Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield,
etc.) are correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
NOTICE: Inspect the Occupant Classification Sensor (OCS) assembly, seat cushion frame and support assembly for any foreign objects
before installing the OCS assembly to the seat cushion frame. If any foreign objects are found, remove them. Failure to follow these
instructions may result in incorrect OCS system operation or failure.
NOTICE: Failure to route the Occupant Classification Sensor (OCS) system components through the correct seat cushion support
opening may cause component failure.
Position the OCS system to the seat cushion frame.
-
Using an OCS system service kit, feed the OCSM, electrical connector, wire harness, pressure sensor and hose through the largest opening at
the front of the seat cushion frame support assembly.
-
Position the seat cushion pad and bladder to the seat cushion frame.
10. Install the OCSM.
1. Position the OCSM and install the rivets.
2. Connect the electrical connector.
-
The OCSM must be correctly positioned and securely riveted in place. Failure to do so may set a DTC in the RCM.
Power seats with an OCS system service kit
11. Tie strap the unused OCS system pressure sensor electrical connector to the seat wiring harness.