Taurus AWD V6-3.5L (2009)
77. NOTE: RH shown, LH similar.
Tighten the 4 subframe bracket-to-body bolts to 103 Nm (76 lb-ft).
78. NOTE: The hex-holding feature can be used to prevent turning of the stud while removing the nuts.
NOTE: RH shown, LH similar.
Install new tie-rod end nuts.
-
Tighten to 115 Nm (85 lb-ft).
79. NOTE: RH shown, LH similar.
Install new upper stabilizer bar link nuts.
-
Tighten to 55 Nm (41 lb-ft).
80. Install the 2 engine roll restrictor-to-transaxle bolts.
-
Tighten to 103 Nm (76 lb-ft).
81. Using a new O-ring seal, install the PSP tube onto the steering gear, rotate the clamp plate and install the bolt.
-
Tighten to 25 Nm (18 lb-ft).
