Taurus AWD V6-3.5L (2009)
98. Using new O-ring seals, connect the A/C tubes and install the 2 nuts.
-
Tighten to 15 Nm (133 lb-in).
99. Using a new O-ring seal, connect the upper A/C tube to the condenser and install the nut and connect the A/C pressure switch electrical connector.
-
Tighten to 15 Nm (133 lb-in).
100. If equipped, attach the block heater wiring harness retainer to the radiator and power steering tube.
101. Connect the transaxle control cable to the shift cable bracket.
102. Connect the transaxle control cable to the control lever.
103. Connect the upper radiator hose, lower radiator hose and heater hose to the thermostat housing.