Taurus AWD V6-3.5L (2009)
Yes
INSTALL a new RCM. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CONNECT all modules. CLEAR
the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
S37 CHECK FOR CORRECT OCSM OPERATION
-
Disconnect the OCSM connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the OCSM connector and make sure it seats correctly.
-
Verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new OCSM. CONNECT all modules. CLEAR the DTCs.
REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. REPOWER the Supplemental
Restraint System (SRS). CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
S38 CHECK FOR CORRECT APIM OPERATION
-
Disconnect the APIM connector.
-
Check for:
-
corrosion
-
damaged pins
-
pushed-out pins
-
Connect the APIM connector and make sure it seats correctly.
-
Verify the concern is still present.
-
Is the concern still present?
Yes
INSTALL a new APIM. CONNECT all modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. REPOWER the SRS. CONNECT all
modules. CLEAR the DTCs. REPEAT the network test with the scan tool.
-------------------------------------------------
Pinpoint Test T: Intermittent No Medium Speed Controller Area Network (MS-CAN)
Communication, Communication Can Be Intermittent
Communications Network
Pinpoint Tests
Pinpoint Test T: Intermittent No Medium Speed Controller Area Network (MS-CAN) Communication, Communication Can Be Intermittently
Established
Normal Operation