Taurus AWD V6-3.5L (2009)
-
Disconnect: SJB Fuses 32 (30A) and 12 (7.5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test J. See: Pinpoint Test J: The Driver Seat Module (DSM) Does Not Respond To The Scan Tool
No
INSTALL the removed fuses. GO to T10.
-------------------------------------------------
T10 VERIFY VEHICLE EQUIPMENT - LTM
-
Inspect the vehicle for a LTM.
-
Is the vehicle equipped with a LTM?
Yes
GO to T11.
No
GO to T12.
-------------------------------------------------
T11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE LIFTGATE/TRUNK MODULE (LTM) DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuses 14 (10A) and 29 (30A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test L. See: Pinpoint Test L: The Liftgate/Trunk Module (LTM) Does Not Communicate With The Scan
Tool
No
INSTALL the removed fuses. GO to T12.
-------------------------------------------------
T12 VERIFY VEHICLE EQUIPMENT - ACCESSORY PROTOCOL INTERFACE MODULE (APIM), REAR ENTERTAINMENT
MODULE (RETM) AND/OR SATELLITE DIGITAL AUDIO RECEIVER SYSTEM (SDARS) MODULE
-
Inspect the vehicle for an APIM, RETM and/or a SDARS module.
-
Is the vehicle equipped with an APIM, RETM and/or a SDARS module?
Yes
GO to T13.
No
GO to T15.
-------------------------------------------------
T13 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RETM AND/OR SDARS MODULE DISABLED