ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2747 > < Initial Inspection and Diagnostic Overview|Page 2745
Page 75
background image

CONNECT the battery ground cable. GO to U32.

No

If the vehicle is equipped with a SDARS module, GO to U24.

Otherwise, GO to U25.

-------------------------------------------------
U24 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE SDARS MODULE
DISCONNECTED

-

Disconnect: SDARS Module C4344.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the battery ground cable. GO to U33.

No

GO to U25.

-------------------------------------------------
U25 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE ACM DISCONNECTED

-

Disconnect: ACM C240c.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 1,000 ohms?

Yes

CONNECT the battery ground cable. GO to U34.

No

If the vehicle is equipped with a LTM, GO to U26.

Otherwise, GO to U27.

-------------------------------------------------
U26 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE LTM DISCONNECTED

-

Disconnect: LTM C4174a.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

Initial Inspection and Diagnostic Overview|Page 2747 > < Initial Inspection and Diagnostic Overview|Page 2745