Taurus AWD V6-3.5L (2009)
4. NOTICE: Failure to route the OCS components through the correct seat cushion support opening may cause component failure.
NOTICE: While positioning the seat cushion frame and OCS assembly, be careful not to damage any of the components. Failure to do so
may result in component failure.
Position the OCS bladder to the seat cushion frame.
-
Feed the pressure sensor and hose through the center opening in the seat cushion frame support assembly.
5. Install the OCS bladder pin-type retainers.
6. NOTE: When the pressure sensor is installed correctly, an audible click will be heard and the pressure sensor will not be able to be removed from
its bracket without disengaging the retaining tab.
Install the pressure sensor.
-
Make sure the pressure sensor hose is routed correctly and is not kinked during installation.
-
Install the pressure sensor onto the seat cushion frame bracket.
-
Make sure the retaining tab is completely engaged.
-
Connect the electrical connector.
7. Position the seat cushion pad and seat cushion trim cover to the seat cushion frame, then attach the hook-and-loop strip at the rear of the seat
cushion trim cover.
8. Attach all the seat cushion trim cover J-clips.
9. If equipped, connect the heated seat electrical connector.
10. Install the seat cushion side shield.
-
If equipped, connect the seat control switch electrical connector.