Taurus X FWD V6-3.5L (2008)
2. Depower the SRS.
3. Remove the center console.
4. Disconnect the small RCM electrical connector.
5. Disconnect the large RCM electrical connector.
1. Pinch the thumb tab and pivot the connector position assurance lever all the way back until it stops
2. Pull out and disconnect the RCM electrical connector.
6. Remove the 3 RCM bolts.
7. Remove the RCM.
Installation
1. Position the RCM.
2. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure
to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
Install the RCM bolts.
To install, tighten to 12 Nm (9 lb-ft).
3. Make sure the connector position assurance lever is in the full release position before attempting to connect the connector.
4. NOTICE: Placing the large Restraints Control Module (RCM) electrical wiring connector into the RCM on an angle, may cause had electrical
connections and damaged components.
Position the large RCM electrical connector into the RCM.
NOTICE: Do not push the co'iiiector to the point where the lever pivots and seats itself Light pressure is needed to get the connector into
position on the Restraints Control Module (RCM), hefore using the lever to fully seat the connector. Failure to follow these instructions may
cause component or connector damage.
With the large RCM electrical connector uniformly aligned to the RCM, lightly push in until a subtle audible click is heard and slight
resistance is felt.
