Taurus X FWD V6-3.5L (2008)
5. Connect the RCM electrical connector.
Pivot the connector position assurance lever toward the RCM, drawing the connector in to the RCM.
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
6. Connect the small RCM electrical connector.
7. Install the center console.
8. Repower the SRS.
9. If a new RCM was installed, carry out the appropriate steps to complete the Programmable Module Installation (PMI) procedure. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning
