Taurus X FWD V6-3.5L (2008)
7. Position the seat cushion pad and seat cushion trim cover to the seat cushion frame, then attach the hook-and-loop strip at the rear of the seat
cushion trim cover.
8. Attach all the seat cushion trim cover J-clips.
Seats with heat
9. Connect the heated seat electrical connector.
Seats with power
10. Install the power seat control switch to the side shield.
All seats
11. Install the side shield and rear screw.
Seats with power
12. Install the power seat switch knobs.
Seats with manual recline
13. Install the recline handle.
All seats
14. Install the passenger seat.
15. WARNING:
-
Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit
components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
-
Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield, etc.) are
correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
To prevent system failure, it is necessary to carry out the occupant classification system (OCS) reset of the OCS when a front
passenger seat cushion is disassembled, a new trim cover installed or an OCS service kit is installed. A scan tool is used to trigger the
command to carry out the OCS reset.
-
To prevent system failure, the following precautions must be taken before carrying out the occupant classification system (OCS) reset:
-
Make sure the voltage to the OCS module is above 8.0 volts and less than 18.0 volts.
-
Make sure the OCS is not at a temperature below 6°C (42°F) or above 36°C (97°F) when initiating the OCS reset process. If the
vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a temperature within the
limits, 6°C to 36°C (42°F to 97°F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS reset and nothing is placed on the seat during the
process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the carrying out the OCS reset
process.
NOTE: If the first attempt to carry out the occupant classification system (OCS) reset is unsuccessful, a second attempt must be made. If the second
attempt to carry out the OCS reset is unsuccessful a second time, a new OCS service kit must be installed.
Carry out the OCS reset.
16. Cycle the ignition switch from ON to OFF.
17. NOTE: The ignition switch must be cycled after carrying out the OCS reset.
