Taurus X FWD V6-3.5L (2008)
-
Sika uses the same black primer for the glass and pinch weld area.
If installing a new rear window glass, apply urethane glass primer according to manufacturer's instructions. Allow at least 6 minutes to dry.
8. Cut the urethane adhesive applicator tip to specification.
9. NOTE: Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and continuous bead.
Apply urethane adhesive on top of the existing trimmed urethane adhesive bead on the pinch weld. Make sure that all gaps in the urethane
adhesive are smoothed into one continuous bead starting and ending at the bottom of the rear window glass near the center.
10. Install the rear window glass on the vehicle aligning it with the markings made previously.
11. WARNING: Do not drive vehicle until the urethane seal has cured. Follow urethane manufacturer's curing directions. Inadequate or
incorrect curing of the urethane seal will adversely affect glass retention. Failure to follow these instructions may result in serious injury
to vehicle occupant(s).
After the urethane has cured, check the rear window glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive
as necessary.
12. Install the headliner, parcel shelf and C-pillar trim panels.
13. Connect the LH and RH heated rear window electrical connector.
