Tempo L4-122 2.0L DSL (1984)
Figure 25
3.
Disconnect the GRAY internal ground connector with black wires, Figure 25. Insert mating connectors of the E43Z-19B573-A jumper harness
between the disconnected internal ground connectors.
4.
Connect jumper harness GREEN connector to relay, E3TZ-9345-A.
5.
Route service clutch coil lead (19B573) along right fender to dash panel and across dash panel to starter motor relay on left fender splash shield.
Secure lead wire with existing wire clips along dash panel.
6.
Connect eyelet of jumper harness lead wire to the positive battery terminal of the starter relay.
7.
Start engine and set A/C system for Maximum. Check for compressor clutch engagement and engine cooling fan operation.
