Removal and Installation Removal | -
Fully extend the steering column. | | -
Detach the steering column upper shroud from the steering column lower shroud. - Using a thin bladed screwdriver, release the two clips (one each side).
| | -
Detach the audio control switch from the steering column lower shroud (if equipped). - Using a thin bladed screwdriver, release the locking tang.
| | -
Remove the audio control switch (if equipped). - Disconnect the electrical connector.
| | -
Remove the steering column lower shroud. - Release the steering column locking lever.
- Remove the retaining screws.
| | -
Disconnect the ignition switch and turn signal/flash to pass electrical connectors. | | -
Remove the ignition switch. - Depress the locking tangs.
| Installation | -
WARNING:Make sure the steering column adjustment lever is in the locked position. Failure to follow this instruction may result in personal injury. CAUTION:Make sure the ignition switch and lock housing are in the OFF position. To install, reverse the removal procedure. | | |