Ford Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Clutch Master Cylinder >
< Clutch Controls
Transit.Tourneo Connect 2002.5 (06.2002-)
Mechanical Repairs
3 Powertrain
308 Manual Transmission-Transaxle, Clutch and Transfer Case
308-02 Clutch Controls
Diagnosis and Testing
Removal and Installation
Clutch Slave Cylinder
Clutch Controls - Clutch Slave Cylinder
Transit/Tourneo Connect 2002.5 (06/2002-)
Removal and Installation
Materials
Name
Specification
Sealant
ESK-M4G269-A
High-temperature grease
ESDM-1C220-A
Removal
Remove the transmission. For additional information, refer to Section
308-03 Manual Transmission/Transaxle
.
Degrease the input shaft splines.
CAUTION:
If brake fluid comes into contact with the paintwork, rinse off the affected areas with cold water without delay.
CAUTION:
Wrap the input shaft splines with adhesive tape to protect the input shaft oil seal.
NOTE:
Do not reuse the clutch slave cylinder.
Undo the bolts and remove the clutch slave cylinder (with thrust bearing).
Installation
CAUTION:
If brake fluid comes into contact with the paintwork, rinse off the affected areas with cold water without delay.
CAUTION:
Do not oil the clutch slave cylinder.
NOTE:
Install a new clutch slave cylinder.
Install the clutch slave cylinder with
a new oil seal and sealant
.
Remove the adhesive tape from the input shaft splines.
Apply a thin film of
high-temperature grease to the input shaft splines
.
Install the transmission. For additional information, refer to Section
308-03 Manual Transmission/Transaxle
.
Mechanical Repairs
3 Powertrain
308 Manual Transmission-Transaxle, Clutch and Transfer Case
308-02 Clutch Controls
Diagnosis and Testing
Removal and Installation
Clutch Slave Cylinder
Clutch Master Cylinder >
< Clutch Controls