Removal and Installation Removal | -
Disconnect the battery ground cable. For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures). | | -
Remove the exhaust gas recirculation valve. For additional information, refer to: Exhaust Gas Recirculation (EGR) Valve - 2.4L Duratorq-TDCi (Puma) Diesel (303-08 Engine Emission Control, Removal and Installation). | | -
Detach the camshaft position (CMP) sensor from the intake manifold. | | -
Remove the intake manifold. | | -
Disconnect and detach the KS electrical connector. | | -
NOTE:Make a note of the position of the KS and make sure it is positioned in the same position when installed. Remove the KS. | Installation | -
NOTE:Prior to installing the KS, clean the engine block and KS mating surfaces with metal surface cleaner. NOTE:Make sure the KS is installed in the same position as removed. To install, reverse the removal procedure. | | |