| Removal and Installation Materials Name Specification Grease A-M1C171-ESA Removal All vehicles | | -
Remove the brake shoes.
For additional information, refer to: Brake Shoes (206-02 Drum Brake, Removal and Installation).
| Vehicles with anti-lock brakes | | -
Detach the rear wheel speed sensor from the brake backing plate. | All vehicles | | -
Detach the parking brake rear cable from the brake backing plate. - Pull back the spring.
- Detach the clip.
| | | -
Using a suitable brake hose clamp, clamp the brake hose. | | | -
CAUTION:If brake fluid is spilt on the paintwork, the affected area must be immediately washed down with cold water. CAUTION:Cap the brake tube to prevent fluid loss and dirt ingress. Remove the wheel cylinder. - Remove the bleed nipple dust cap.
- Disconnect the brake tube.
- Remove the bolts.
| Vehicles with 2.4L diesel engines | | -
Remove the axle shaft. For additional information, refer to: (205-02B Wheel Hubs and Bearings - Full Floating Axle) Axle Shaft - Vehicles With: Single Rear Wheels (Removal and Installation), Axle Shaft - Vehicles With: Twin Rear Wheels (Removal and Installation). | | | -
Remove the brake backing plate. | Vehicles with 2.0L diesel engine | | -
Remove the brake backing plate. | Installation All vehicles | | -
Clean the brake backing plate and apply grease to the brake shoe contact points. | | | -
To install, reverse the removal procedure. | Vehicles with 2.0L diesel engine Vehicles with 2.4L diesel engine All vehicles Vehicles with anti-lock brakes | | -
Bleed the brake system.
For additional information, refer to: Brake System Bleeding (206-00 Brake System - General Information, General Procedures).
| |
