ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Steering Gear Boot > < Diagnosis and Testing|Removal and Installation|Tie Rod

Transit 2006.5 (04.2006-)

Steering Linkage - Tie Rod End Transit 2006.5 (04/2006-)
Removal and Installation

General Equipment
Two leg puller

Removal

  1. Remove the front wheel and tire.
    For additional information, refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).

  1. CAUTION:
    CAUTION:Leave the tie-rod end retaining nut in place to protect the ball joint stud.
    Loosen the tie-rod end locknut and the tie-rod end retaining nut.
    1. Loosen the locknut.
    1. Loosen the retaining nut.

  1. CAUTION:
    CAUTION:Protect the ball joint seal using a soft cloth to prevent damage.
    Using a suitable two leg puller, detach the tie-rod end from the wheel knuckle.
    1. Release the tie-rod end.
    1. Remove and discard the tie-rod end retaining nut.

  1. NOTE:
    NOTE:Make a note of the number of turns used to remove the tie-rod end.
    Remove the tie-rod end.

Installation
  1. WARNING:
    WARNING:Install a new tie-rod end retaining nut. Failure to follow this instruction may result in personal injury.
    NOTE:
    NOTE:Install the tie-rod end using the same number of turns used to remove it.
    To install, reverse the removal procedure.
  1. Adjust the front wheel alignment. For additional information, refer to: (204-00 Suspension System - General Information)
    Specifications (Specifications),
    Front Toe Adjustment (General Procedures).

Steering Gear Boot > < Diagnosis and Testing|Removal and Installation|Tie Rod