ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Coolant Outlet Connector - 2.3L Duratec-HE (MI4) > < Coolant Pump - 2.2L Duratorq-TDCi (Puma) Diesel

Transit 2006.5 (04.2006-)

Engine Cooling - Coolant Pump—2.3L Duratec-HE (MI4) Transit 2006.5 (04/2006-)
Removal and Installation

Materials
Name
Specification
Grease
ESE-M99B144-A

Removal

NOTE:
NOTE:Removal steps in this procedure may contain installation details.
  1. Drain the cooling system.
    Refer to: Cooling System Draining, Filling and Bleeding - 2.3L Duratec-HE (MI4), Vehicles Without: Fuel Fired Booster Heater (303-03 Engine Cooling, General Procedures).
    Refer to: Cooling System Draining, Filling and Bleeding - 2.3L Duratec-HE (MI4), Vehicles With: Fuel Fired Booster Heater (303-03 Engine Cooling, General Procedures).

  1. Loosen the coolant pump pulley bolts.
    Torque: 20 Nm
  1. Remove the accessory drive belt.
    Refer to: Accessory Drive Belt - 2.3L Duratec-HE (MI4) (303-05 Accessory Drive, Removal and Installation).
  1. Lower the vehicle.

  1. NOTE:
    NOTE:The O-ring seal is to be reused unless damaged
    Material: Grease
    Torque: 10 Nm

Installation

  1. To install, reverse the removal procedure.

Coolant Outlet Connector - 2.3L Duratec-HE (MI4) > < Coolant Pump - 2.2L Duratorq-TDCi (Puma) Diesel