Transit Connect L4-2.0L (2010)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the wheel speed sensor bolt.
-
To install, tighten to 9 Nm (80 lb-in).
3. Disconnect the wheel speed sensor electrical connector.
-
Remove the sensor by detaching the pin-type retainer and pulling the sensor grommets out of the clips.
4. To install, reverse the removal procedure.