Windstar V6-232 3.8L (1995)
Sliding Door Interior Trim Panel: Technical Service Bulletins
Interior Trim Panel - Removal/Installation Service Tips
Article No.
94-8-10
04/20/94
INTERIOR TRIM - LX TRIM PANEL REMOVAL AND INSTALLATION PROCEDURES - SERVICE TIPS
LIGHT TRUCK:
1995 WINDSTAR
ISSUE:
Integral foam blocks are incorporated on the sliding door trim panel of vehicles equipped with the "LX" trim package. These foam blocks provide
improved protection for the 2nd row RH LX bucket seat occupant.
ACTION:
If vehicles with LX trim level are involved in a collision or sustain other damage to the sliding door assembly in which the foam blocks on the LX trim
panel are damaged, the sliding door trim panel MUST be replaced. Remove the panel and fasteners and inspect the foam blocks for damage. If any
damage is observed, replace the trim panel (new fasteners are pre-assembled to the replacement trim panel). Refer to the following procedure for service
details.
WARNING:
THE FOAM BLOCKS ON THE TRIM PANEL PROVIDE IMPROVED PROTECTION FOR THE 2ND ROW RH LX BUCKET SEAT
OCCUPANT.
WARNING:
"LX" TRIM PANELS CANNOT BE REPLACED WITH "GL" LEVEL TRIM PANELS.
CAUTION:
TAKE CARE NOT TO DAMAGE THE FOAM BLOCKS DURING HANDLING.
NOTE:
LX TRIM PANELS REQUIRE THE USE OF THE LX WATERSHIELD.
TRIM PANEL REMOVAL
1.
It is recommended that the sliding door assembly is swung open on its front hinges/runners to allow better access to the door trim panel and thus
prevent damage to the foam blocks during panel removal. This requires the release of the rear runner from its track. The procedure for releasing
the rear runner from its track is covered in the 1995 Windstar Service Manual, Section 01-03.
2.
Release the upper glass trim and fasteners.
3.
Unscrew and remove the lock "soldier button."