Windstar V6-232 3.8L (1995)
Fluid Pump: Service and Repair
Pump Assembly and Main Control Valve Body
Removal and Installation
SPECIAL SERVICE TOOL(S) REQUIRED
Valve Body Guide Pin: T86P-70100-C
REMOVAL
Valve Body Bolt Removal
1. Remove Air Cleaner (ACL) assembly.
2. Disconnect battery ground cable and positive battery cable.
3. Remove battery and battery tray.
4. Disconnect Transmission Range (TR) sensor and transaxle harness electrical connectors and reposition engine wire harness.
5. Place TR sensor manual lever in PARK position.
6. Install Three Bar Engine Support D88L-6000-A with Engine Lifting Eyes from Engine Lift Bracket Set 014-00796 or equivalent and support
engine assembly.
7. Remove main control cover upper retaining bolts.
8. Raise and suitably support vehicle on hoist.
9. Remove LH front wheel tire and wheel assembly.
10. Remove LH front fender splash shield.
11. Remove LH engine support and insulator.
12. Position drain pan under transaxle side pan and remove remaining lower transaxle side pan bolts and remove transaxle side pan and gasket.
13. Disconnect Transmission Fluid Temperature sensor (TFT sensor) from main control valve body and solenoid electrical connectors.
14. Remove transaxle wiring harness from chain cover.
15. Remove main control valve body retaining bolts, disconnect manual linkage and carefully slide pump assembly and main control valve body off of
pump shaft and remove from transaxle.
CAUTION: Do not remove pump assembly cover bolts.
