Windstar V6-3.8L VIN 4 (1997)
Accelerator Controls
1. Install accelerator cable through dash panel into passenger compartment, making sure retaining clips are fully seated.
CAUTION: Make sure accelerator cable is routed as shown in illustration.
2. From inside vehicle, attach accelerator cable end to accelerator pedal and shaft, seating retainer on accelerator cable end onto accelerator pedal
and shaft.
NOTE: Accelerator cable retainer must be fully seated in slotted hole on accelerator pedal and shaft.
3. Install accelerator cable in attaching accelerator cable bracket on intake manifold, making sure that tab or pin on accelerator cable aligns with hole
in accelerator cable bracket.
4. Attach accelerator cable end to throttle lever at throttle body.