Sprinter 2500 V6-3.0L DSL Turbo (2008)
Drive Belt Tensioner: Description and Operation
Operation
OPERATION
WARNING: The automatic belt tensioner assembly is spring loaded. do not attempt to disassemble the tensioner assembly.
The automatic belt tensioner maintains correct belt tension using a coiled spring within the tensioner housing. The spring applies pressure to the
tensioner arm pressing the arm into the belt, tensioning the belt.
If a new belt is being installed, the arrow must be within approximately 3 mm (1/8 in.) of indexing mark. Belt is considered new if it has been used 15
minutes or less. If this specification cannot be met, check for:
-
The wrong belt being installed (incorrect length/width)
-
Worn bearings on an engine accessory (A/C compressor, power steering pump, water pump, idler pulley or generator)
-
A pulley on an engine accessory being loose
-
Misalignment of an engine accessory
-
Belt incorrectly routed.