Sprinter 2500 V6-3.0L DSL Turbo (2008)
5. Tighten the bolts in three stages following the sequence provided. First to 4 Nm (35 in. lbs.), then to 6 Nm (53 in. lbs.), and then to 8.4 Nm (75 in.
lbs.).
CAUTION: The fuel injector sealing washers MUST be replaced. DO NOT use the old sealing washers or double the sealing washers.
NOTE: Care must be taken not to apply any lubricant to the fuel injector nozzles.
6. Lubricate the fuel injector bodies and install the fuel injectors (1). Install the injector retaining claws and tighten the bolts to 7 Nm plus 180 °(62
in. lbs. plus 180°).
7. Install the EGR valve (1).
8. Install the engine harness fasteners (2), route the return fuel hose, and injector harness.
9. Install the fuel rail (4) and high pressure lines.
10. Install the left rear engine cover bracket.
