Sprinter 2500 V6-3.0L DSL Turbo (2008)
Water Pump: Service and Repair
Water Pump - Removal
REMOVAL
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling
system unless coolant temperature is below 90°C (194°F)). Open cap slowly to release pressure. store coolant in suitable and appropriately
marked container. Wear protective gloves, clothes and eye wear.
NOTE: Inspect condition of all clamps and hoses, replace as necessary.
1. Disconnect the negative battery cable.
2. Drain cooling system See: Cooling System/Service and Repair
3. Remove viscous fan clutch.
4. Detach fuel lines from the brackets at the water pump.
5. Detach the coolant hoses at the water pump.
6. Press off cap at belt guide pulleys.
7. Remove belt guide pulleys.
8. Remove water pump retaining bolts and remove water pump.
