Sprinter 2500 V6-3.0L DSL Turbo (2008)
Drive Belt: Service and Repair
Serpentine Accessory Drive Belt - Installation
Serpentine Belt
3.0L DIESEL
CAUTION: When installing the accessory drive belt, the belt must be the correct length and routed correctly. If not, engine may overheat due
to water pump rotating in wrong direction.
1. Position drive belt over all pulleys except water pump pulley.
2. Using a suitable tool, rotate accessory drive belt tensioner counterclockwise. Place belt over all pulleys. Let tensioner rotate back into place. Be
sure belt is properly seated on all pulleys.
3. Install fan drive pulley See: Serpentine Belt.
Cooling Fan Serpentine Belt
3.0L COOLING FAN SERPENTINE BELT
1. Position the fan drive belt (2) onto the water pump pulley (1).
2. Position the fan drive belt (2) onto the crankshaft pulley (3).
NOTE:Use only wire ties with nylon locks, not metal.
3. Working from the back side of the crankshaft pulley (3), insert a nylon wire tie, 196.8mm X 3.175mm X 12.7mm (7.75 in. X 0.125 in. x 0.50 in),
